The Optimise PV immersion controller
What do the LEDs mean?
The Red and Yellow LEDs come on at the wrong time?
This usually happens if the current sensor is back to front, try reversing the sensor.
The current sensor is installed around the live wire (or the neutral wire) on the grid tails. If it is on the live wire, then the arrow should point to the grid, if it is on the neutral then the arrow must point away from the grid.
The Green LED is always on?
The Green LED indicates that the immersion heater is not drawing any power. If the immersion is working normally then it means it is up to temperature, however if the Green LED comes on straight away and stays on then it could indicate a faulty immersion heater. There are a few things to check:
Where should I install the current sensor?
The current sensor must be connected around the incoming live wire, before the PV system and consumer unit.